IQ2 features update?

[NNN635632006621552168]

Hi, I am using IQ260 with DF+.
Will IQ260 backs gain any of the IQ3 features / tools when used on the DF+?
Or Does Phaseone have any plan for new feature update for IQ2 user?

[Ulf]

HI

Many of the new tools which are launched with IQ3 will be available for IQ2 as well with new firmware.
Some will not be available due to physical limitations, like power share (requires both IQ3 and XF with power pins) or extended camera control which the DF+ does not support but with be available when you put the IQ2 on a XF.

[NNN635632006621552168]

Thank you for the reply.

[LSdigi.com]

HI

Many of the new tools which are launched with IQ3 will be available for IQ2 as well with new firmware.
Some will not be available due to physical limitations, like power share (requires both IQ3 and XF with power pins) or extended camera control which the DF+ does not support but with be available when you put the IQ2 on a XF.

what about charging over USb3 with new firmware (while using a supported hub?) for IQ2 backs? That would be a life saver. So tired of changing batteries 10x times a day!

[frederic_h]

Is that IQ2xx firmware update still in the works ? Haven't heard anything since the announcement.

[Drew]

Is that IQ2xx firmware update still in the works ? Haven't heard anything since the announcement.

This was released in late June/Early July. Simply update to current IQ2 firmware and you're all set.
https://www.phaseone.com/en/Downloads/M ... mware.aspx

[frederic_h]

Thanks Drew, though your link takes us to the IQ + XF firmwares, not to the IQ + DF ones like the OP was asking for.

It was my understanding the IQ2xx would get the heat map and raw clipping warning tools through an update. Are those only available for use with an XF then ?

[Ulf]

Hi

It is one firmware for all.
And the features are available irrelevant to if you use DF, DF+ or XF

[frederic_h]

Indeed, thanks !

For some reasons C1 update notifications were not turned on for this back.