Multi Connector with an IQ2 and 555

Questions, comments and suggestions regarding Phase One IQ4, IQ3, IQ2 and IQ1 series digital camera backs.

Multi Connector with an IQ2 and 555

Postby Matt32 » Thu Jan 22, 2015 7:37 pm

Anyone have a solution to use the multi connector when the IQ back is mounted vertically? Like a multi connector pig-tail or a smaller form factor multi connection?

I can use the standard sync port, but in the event that port does not work I'm kind of screwed.

I could always dremel away at the battery grip of the 555 as well, but that is sketchy.
Matt32
 
Posts: 35
Joined: Tue May 07, 2013 6:01 am

Re: Multi Connector with an IQ2 and 555

Postby Ulf » Fri Jan 23, 2015 4:22 pm

Hi

It is only possible on V cameras which does not have the motor drive.
But I believe your worry is unfounded.
The standard sync port has a failure rate is extremely low.
Ulf
Crew
Crew
 
Posts: 3521
Joined: Wed Oct 06, 2004 1:52 pm
Location: Copenhagen Denmark

Re: Multi Connector with an IQ2 and 555

Postby Matt32 » Fri Jan 23, 2015 9:41 pm

Not entirely unfounded... My dealer has since sorted it out.

I just like to have backup solutions on hand when possible. But I trust that it is a rare occurrence.
Matt32
 
Posts: 35
Joined: Tue May 07, 2013 6:01 am


Return to Phase One IQ4, IQ3, IQ2 and IQ1 series camera backs



Who is online

Users browsing this forum: No registered users and 2 guests