bad results after processing images

[NN635063277120978108UL]

Hello board members,

after having edited my raws, they look like I wanted them to be. But then, after prcessing (in this case JPG) they look completely changed like "wiped over" as if they had very few pixels.
The last time, I had used C1pro6 everything had been all right. So i think I changed something within the parameters without knowing...

Does anybody know about that problem and how to solve ist? .... I would be grateful,


Sabine

[Paul_Steunebrink]

Hi Sabine,

I suggest you take a look at your process recipe. Maybe you have selected the QuickProof, or the scale parameter is set to a low value. Also, the ICC profile is worth checking (sRGB is a safe bet for troubleshooting at the least).

[NN635063277120978108UL]

Hi Paul,

thanks a lot for your answer! I hope you still read this thread, there was a long break now before answering...

I checked the process recipe. No bad Idea. It worked a bit for once but I couldn´t repeat it.
The ICC is correct, JPG is on 100%, and the scaleparameter -the parameter that changed the result a bit for good - is on "fixed" and 100%. (The change ocurred after I had used a smaller value than 100 %) The resolution is set: 300 pix/in.
Do you see anything, I should change?
Which parameters do you use in your process recipe?

Sabine

[Paul_Steunebrink]

Hi Sabine,

Yes, still online and reading posts!
It seems your process recipe is OK. You could do the following however:
- create a new recipe with similar settings and see whether that makes any difference
- try to show us how your output may look like, we are still guessing somewhat
- try to make an output image downloadable so others can have a look and perhaps a tip or solution

Or you can take a shortcut and contact Phase One in a support case.