Page 1 of 1

Logo/Watermark place not the same on print

PostPosted: Tue Dec 04, 2018 2:22 pm
by paul-photography
Hello,
I would like to use my logo on the print when i print an image from C1. I placed my logo as kind of watermark image in the bottom right corner in a readable size. But after the print, i found my logo in the center and in almost unreadable size.
The paper size is A3 and my logo was created in png.
Could anybody help me, what could be the problem?
Thank you in advance.

Re: Logo/Watermark place not the same on print

PostPosted: Tue Dec 04, 2018 2:48 pm
by Paul_Steunebrink
Where did you configure your watermark? Was it in the print dialog or in a process recipe, watermark tab?

Re: Logo/Watermark place not the same on print

PostPosted: Tue Dec 04, 2018 3:49 pm
by paul-photography
I configure it in the print dialog watermark session.

Re: Logo/Watermark place not the same on print

PostPosted: Tue Dec 04, 2018 3:54 pm
by paul-photography
Could you explain how the recipes works when i print?

if i push the print button, i get a raw picture for printing and used the choosed icc profile from print dialog, or i get the recipe edited picture for print dialog?
Example: If i set in a recipe output sharpening for print, than i choose this recipe and push the print button, i'll get the sharpened picture? Or it works only for export process?

Thank you.