Page 1 of 1

Focus difference in 6 vs. 7 engine

PostPosted: Wed Nov 07, 2012 5:15 pm
by Shawn2
Hello all,

I opened a job in 6 & in 7 and there is a substantial way the focus looks. The 7 engine seems to make the sharpening (5d mk 3) look more chunky when compared to the smooth gradations in areas such as hair in 6.

Anyone else experience this?

Re: Focus difference in 6 vs. 7 engine

PostPosted: Wed Nov 07, 2012 8:33 pm
by Terence2
Turn the Details (in the focus tab) tool to 0.

Re: Focus difference in 6 vs. 7 engine

PostPosted: Wed Nov 07, 2012 9:12 pm
by Shawn2
I do not see the details that you speak of.

If you have an opportunity check out the difference between the two engines (open a session from 6) in 7 without changing the engine then convert the engine to 7.

Re: Focus difference in 6 vs. 7 engine

PostPosted: Thu Nov 08, 2012 10:28 am
by David Grover
Hi Shawn,

Its in Noise Reduction Advanced.

You might have to play with the Noise Reduction, NR ADvanced and Sharpness settings to get the look you like.

We have tried to make the conversion from a 6 engine image to a 7 engine image as close as possible but some personal preference maybe required.

D

Re: Focus difference in 6 vs. 7 engine

PostPosted: Thu Nov 08, 2012 11:59 pm
by thowi
David Grover wrote:We have tried to make the conversion from a 6 engine image to a 7 engine image as close as possible...
The details setting in Advanced NR makes quite a difference. By default (Details = 50) V7 is not really close to V6. Then again you are right: simply adjust the Details default to meet your personal taste and everything is fine.

David, just noticed your are now employed by Phase One - cool!! Good luck for your new (?) job!
Thomas