Tethered shoot on Surface Pro

Questions, comments and suggestions regarding Leaf Credo series digital camera backs.

Tethered shoot on Surface Pro

Postby harshdreams » Tue Oct 04, 2016 7:43 am

I am trying to hook up my Leaf credo 40 (latest firmware updated) with a Surface Pro 3 (widows 10) and run it over USB3, however capture one pro (latest 9.3) is not able to detect the credo. I tried the same setup with a macbook pro and my iMac and it is able to detect the back and is fine. So the problem is not with the cable or the back. I do make all the necessary changes in preferences in capture one on Windows prior to connecting the back. Is there some setting on the Surface pro i am missing out? are leaf drivers to be installed separately? i have tried out everything i could but am still am not able to figure this out.
harshdreams
 
Posts: 1
Joined: Wed May 16, 2012 4:59 pm

Re: Tethered shoot on Surface Pro

Postby Ulf » Wed Oct 12, 2016 8:44 am

HI

This should work just fine.
It is probably just a matter of installing drivers.
If you need assistance from Phase One then raise a support case on http://support.phaseone.com
Kind Regards
Ulf Liljegren
Phase One
Ulf
Crew
Crew
 
Posts: 3364
Joined: Wed Oct 06, 2004 1:52 pm
Location: Copenhagen Denmark


Return to Leaf Credo series camera backs



Who is online

Users browsing this forum: No registered users and 1 guest