Cannot get IQ310 back to accept new offset in alignment tool

[Rogerxnz]

I get to the point where I have the change offsets ticked and I press "set". The screen with the large alignment display appears with an "X" and a tick. I tap the tick button but no matter how many times I do this, the screen does not go back to the previous screen and I cannot turn off offset changes.

The only way I can exit the large alignment display is to tap the "X", which cancels the whole procedure.

How do I get the new offset to be accepted?
Roger

[Paul Richards Harrogate UK]

I would try downloading the latest software again and see if it helps otherwise contact P1