Page 1 of 1

Sad reality of moving to MFD

PostPosted: Sat Jun 30, 2018 8:24 am
by NNN636463445634415489
Well, finally what I have dreaded all the time has happened:
My RZ67ProIID does not communicate with the IQ160 back at all.
I keep powering camera and back off together and in turns, removing and re-attaching the back over and over but alas.

I have tried emergency mode with the X-port->sync cable but back keeps on nagging: "One shot delay is too long, should be shorter than 4 sec" or "One shot delay is too long, should be shorter than 1sec"..
So, perhaps cable worked in theory some long time ago - it's definitely not working in reality!

Except that, I can't see how it is possible to use X-port for triggering AND controlling strobes as well.
So far it managed ONE capture in portrait mode, and as soon as you rotate it landscape it goes dead....going back to portrait doesn't help at all.

I have 3 days left until I travel and have a rather complex project planned....and it looks as I will have to go back to Canon 5D MkIII, which is just abysmal! Though at least it has worked for more than 2 years.. :evil:

Re: Sad reality of moving to MFD

PostPosted: Sat Jun 30, 2018 11:16 pm
by C-M-B
Do you have a spare camera? A backup to see whether it's the back or the camera that's faulty?

Re: Sad reality of moving to MFD

PostPosted: Fri Jul 13, 2018 7:46 pm
by Jon
Sorry to hear about this and I hope you found a solution before your trip! Keep in mind that technical issue are better sent to us on our support page so we can help same day.

On the surface it sounds like your adapter plate has failed. This of course can be repaired, but in the short term, the workaround is to use a cable like you mentioned testing. For the cable to work though you have to do one of 2 things:

1. With Shutter Latency set to Normal on the back, there needs to be two signals sent to the back to work. You can either use a Phase Oe wakeup cable and press the wakeup button before shooting, or fire the camera twice within 4 seconds. The first shout will be the wakeup and the second the exposure.

2. Set Shutter Latency to Zero and use the cable - this mode will not require the wakeup signal, but will use significantly more battery power and can cause the back to get too hot. The best way to work in this mode is to turn off the back when you aren't actively shooting.