Page 1 of 1

Can I reset the alignment (levelling) tool on an IQ3-100?

PostPosted: Sun May 20, 2018 1:54 pm
by Rogerxnz
My alignment tool is out of alignment and I have read that older backs show a reset button when you press on the small alignment tool. I don't see a reset button on the IQ3-100 when I press the alignment tool icon.

The alignment tool is the tool which allows you to level the back/camera in two dimensions. It's a circle with two scales, one below and one to the right of the circle.

So, is it possible to reset the alignment tool on an IQ3-100?
Roger

Re: Can I reset the alignment (levelling) tool on an IQ3-100

PostPosted: Tue May 29, 2018 6:54 pm
by Jon
The Option you are looking for is Offset. Press and hold on the pitch and roll icon, then click Set in the Pitch and Roll Offset. Level the camera (do this based on the actual images rather than rely on a bubble level) and click the check box to accept the new 0* position.

Keep in mind as the back heats up during use, the pitch and roll sensor can drift slightly.