Page 1 of 1

Multi Connector with an IQ2 and 555

PostPosted: Thu Jan 22, 2015 7:37 pm
by Matt32
Anyone have a solution to use the multi connector when the IQ back is mounted vertically? Like a multi connector pig-tail or a smaller form factor multi connection?

I can use the standard sync port, but in the event that port does not work I'm kind of screwed.

I could always dremel away at the battery grip of the 555 as well, but that is sketchy.

Re: Multi Connector with an IQ2 and 555

PostPosted: Fri Jan 23, 2015 4:22 pm
by Ulf
Hi

It is only possible on V cameras which does not have the motor drive.
But I believe your worry is unfounded.
The standard sync port has a failure rate is extremely low.

Re: Multi Connector with an IQ2 and 555

PostPosted: Fri Jan 23, 2015 9:41 pm
by Matt32
Not entirely unfounded... My dealer has since sorted it out.

I just like to have backup solutions on hand when possible. But I trust that it is a rare occurrence.