Strobe won't fire

Questions, comments and suggestions regarding Phase One P+ series and P series digital camera backs.

Strobe won't fire

Postby Dave Abrams » Wed Jun 03, 2009 11:08 pm

We're using a P45 back with a Schnieder Kreuznack 120 on Mac V10.3.9 with Capture One 3.7.7. Today, out of the blue, tripping the shutter no longer fired the strobe. When I bypass the back and go directly to the pack it fires. We tried it on another computer and it didn't work there as well. A P 21 fired the strobe once but not again. The same for an H20 on a Hassie. The P21 and the H20 work fine on the second computer. Any ideas?

Turned out it was the cable from the back to the strobe. Curious though because when connected directly to the lens it fired. Must have been an ohm issue.
Dave Abrams
 
Posts: 1
Joined: Thu Jun 04, 2009 12:42 am

Return to Phase One P+ and P series camera backs



Who is online

Users browsing this forum: No registered users and 2 guests