Page 1 of 1

P30+ sync/minijack connections worn

PostPosted: Mon Sep 03, 2018 2:34 pm
by Saul G
Hi

I have a P30+ back which works but the connections to both mini jack sync ports on the back are loose. Is it possible to adjust them to be firm again or do they need replaced? and if so what is the cost?

Also as curious, the P30+ has a multi connector port which can be used to connect to the lens sync via a multi connector to lens sync cable (part 50300143) when used with large format. Could this multi connector to lens sync cable be used instead of the standard lens sync to mini jack on a 503cw ? Just thinking it might be cheaper than an expensive repair!!

Regards
Saul

Re: P30+ sync/minijack connections worn

PostPosted: Tue Sep 04, 2018 9:05 am
by Ulf
Hi
Contact your local Phase One partner for service cost and arrangement.
You can locate your local Phase One partner here:
https://www.phaseone.com/en/about-us/pa ... cator.aspx

If you are on a Hasselblad V then you can use the multi sync port the same way you use the mini jack ports.
Either with the 50300143 or with the minijack to multi sync adapter 50300144
https://www.phaseone.com/en/Search/Arti ... nguageid=1

Re: P30+ sync/minijack connections worn

PostPosted: Tue Sep 04, 2018 9:44 am
by Saul G
Hi Ulf

Many thanks for the reply & good news about the multi sync :)

Cheers
Saul