Partial lines runnign across scan

Question regarding:Phase One H25, H20, H101, H10, H5, LightPhase, PowerPhase FX / FX +, PowerPhase, PhotoPhase and StudioKit.
Leaf Valeo, C-Most, Cantare, Volare and DCB.

Partial lines runnign across scan

Postby monkeyfist » Sat Jan 17, 2015 7:34 pm

Hello

Anyone have idea what might cause something like this?

Image

Image

It's weird, as the lines do not go from end to end. So i assume it's not the sensor that is causing the problem.

Also, at first they were much more faint. After scanning for some time, they got much more pronounced and another line appeared next to it.

Image

I'm running Photophase PLUS on OS 9.2.
monkeyfist
 
Posts: 5
Joined: Sat Aug 09, 2014 4:27 pm

Re: Partial lines runnign across scan

Postby Ulf » Mon Jan 19, 2015 11:18 am

Hi

Multi coloured lines like this is dirt / grease on sensor.

Use cleaning position in the software.

Clean sensor CCD cleaning solution.
Kind Regards
Ulf Liljegren
Phase One
Ulf
Crew
Crew
 
Posts: 3399
Joined: Wed Oct 06, 2004 1:52 pm
Location: Copenhagen Denmark

Re: Partial lines runnign across scan

Postby monkeyfist » Mon Jan 19, 2015 3:06 pm

Thanks for the reply.

If it's just that, it sounds good. But i did clean the sensor just recently.. i'll try to clean it again and see if it makes a difference.
monkeyfist
 
Posts: 5
Joined: Sat Aug 09, 2014 4:27 pm


Return to Phase One and Leaf Legacy one-shot and scan camera back



Who is online

Users browsing this forum: No registered users and 1 guest