Page 1 of 1

P25

PostPosted: Sat Nov 27, 2004 12:36 pm
by Ashley11
Can't get the cable to fit into the P25 back when I put it on the FlexAdapter.
Any suggestions ?

cable

PostPosted: Sun Nov 28, 2004 9:36 am
by a_dan
i have the same problem with H101 and Flexadapter - i destroy the top of original Phaseone cable and then it begin to work. there is no dealer's answer for a year already for this problem :cry:

PostPosted: Sun Nov 28, 2004 6:55 pm
by Ulf
With the P25 you should use the Multi purpose port instead of the normal Hasselblad sync cable, cable with this type of connector came in the box if not then please contact your dealer.
With H101 there is a special cable due to the tight fitting, this can be ordered through your dealer.

using p25 with lf

PostPosted: Fri Mar 18, 2005 4:55 pm
by larryg
I have the P25 for Contax I also have a Toyo 45AII large format system
Will the large format adapter work on this camera body (Toyo)?
No one seems to know for sure (at local camera stores)

PostPosted: Tue Mar 22, 2005 9:03 pm
by Ulf
A flexadapter with Toyo fitting and a Contax insert plate should work just fine for you.

Flex adapter for Toyo 45AII

PostPosted: Wed Mar 23, 2005 2:50 am
by larryg
Thanks for your response. This is good news, since I already have a lf system.

FYI the Toyo 45AII is a field camera, if that makes any difference?

PostPosted: Thu Mar 24, 2005 2:55 pm
by Ulf
Not as long as the physical film plan fitting is the same as the normal view camera and there is not anything blocking the fitting of the flexadapter on either side.